Description:
Wholesale Price Liquid AB Glue Crystal Jewelry making Clear Epoxy Resin for River Resin Table is a two part clear epoxy resin system, 1:1 ratio,100% Solids ,Advanced Air Release,Compatible With Many Pigments, Enhanced Color Stability, Excellent U.V. Resistance, Extended Working Time, High Gloss Finish, No VOCs, Non Flammable, Pour up to 2" Thick,Self-Leveling, Water Resistant, Water-Clear Cure.
It is a kind of low viscosity, high transparency, alternative anti-ultraviolet modified epoxy resin, with excellent anti-reflection, excellent surface gloss after curing, high hardness, strong whitening resistance, suitable for higher requirements of wooden river table .
Application:
Perfect for Jewelry, Coasters, Tumblers, Small Castings, Woodworking, and much more
Features:
DIRECTIONS FOR USE:
Step 1: The ideal working temperature is around 77°F. Best results can be obtained at temperatures between 70°F and 85°F, in a
clean, dry, dust-free environment. Avoid working in high humidity. We recommend using this product on a leveled and flat work
surface.
Step 2: Measure product in accordance with your intended use. Prepare 2 parts Base Resin to 1 part Curing Agent by liquid volume.
Pour the Curing Agent first and then the Base Resin into a clean, smooth-sided container large enough to hold all the liquid and
allow room for mixing.
Step 3: The material must be mixed thoroughly for at least 6-8 minutes. Be sure to scrape the container sides, bottom, and corners
as you mix. Be careful not to whip excessive air into the mixture. If mixing a gallon, use a power mixer set to "hand speed." For
smaller quantities, use stir sticks. Do not mix more than a gallon. Pour into a new, clean container and mix for an additional
minute.
Step 4: Pour the mixed resin onto the surface and distribute evenly with a squeegee or gloved hand. Continue to pour remaining
material to achieve the desired thickness, allowing the resin to flow evenly over the project's sides. Resin can be poured up to
2" thick per pour, and up to 4" depending on the volume of the pour.
Step 5: Use a heat source such as a heat gun to remove any bubbles by adding a small amount of heat to the surrounding area. The
bubble will rise to the surface and pop.
Step 6: If you are going to make a second pour, the first pour should still be slightly sticky. Once the second pour is made,
bubbles may once again need to be removed. Material will feel hard after 48-72 hours, but full cure and maximum hardness can
require up to 7 days, depending upon the temperature.
PRO TIP: If you wish to apply paper decals or other objects under the surface, those objects need to be bonded to
the surface either with Epoxy or craft glue. Some wood may take the material well in a single coat; however, many types
of wood require a seal coat to prevent air bubbles from rising out of the wood and ruining the surface. Older, more porous pieces
of wood may contain both air and moisture that can contaminate the finish. In this case, the user may first paint on a very thin
coat of SuperClear Table Top Epoxy, allowing that to set before pouring the new layer.
Using instruction:
Packing:
5kg/drum, 20kg/drum, 200kg/drum
Audited Supplier 
){kind=link}
){kind=link}